Specifications

15
10H115
100
Ω
74LVT244
42 Ω
348 Ω
100EL90
42
Ω
215 Ω
100LVEL90
Pattern Generator Specifications and Characteristics
(16821A, 16822A, and 16823A) (continued)
Agilent 10465A ECL data pod (unterminated)
Output type 10H115 (no termination)
Maximum clock 300 MHz
Skew
1
Typical < 1 ns; worst case = 2 ns
Recommended lead set Agilent 10347A
Agilent 10466A 3-state TTL/3.3 volt data pod
Output type 74LVT244 with 100 Ω series;
10H125 on non 3-state channel 7
2
3-state enable Negative true, 100 KΩ to GND,
enabled on no connect
Maximum clock 200 MHz
Skew
1
Typical < 3 ns; worst case = 7 ns
Recommended lead set Agilent 10474A
Agilent 10469A 5 volt PECL data pod
Output type 100EL90 (5 V) with 348 ohm pulldown
to ground and 42 ohm in series
Maximum clock 300 MHz
Skew
1
Typical < 500 ps; worst case = 1 ns
Recommended lead set Agilent 10498A
Agilent 10471A 3.3-volt LVPECL data pod
Output type 100LVEL90 (3.3 V) with 215
Ω
pulldown to ground and 42 Ω in
series
Maximum clock 300 MHz
Skew
1
Typical < 500 ps; worst case =
1 ns
Recommended lead
set
Agilent 10498A
1. Typical skew measurements made at pod connector with
approximately 10 pF/50 KΩ load to GND; worst case skew
numbers are a calculation of worst case conditions through
circuits. Both numbers apply to any channel within the
pattern generator.
2. Channel 7 on the 3-state pods has been brought out in parallel
as a non 3-state signal. By looping this output back into the
3-state enable line, the channel can be used as a 3-state
enable.