Specifications

159
Chapter 1: Agilent Technologies 16700A/B-Series Logic Analysis System
The System Administration Tools
For more information on the user environment, refer to The User
Environment and Session Control (see page 172).
The default factory configuration is the open-networked unsecured
mode. Use the following procedures to set up user accounts and add
security to your system through the Secure Mode. You can set up user
accounts either individually, or by importing a file.
NOTE: Any user can set up user accounts and become the system administrator the
first time the User Accounts dialog is accessed. To modify user account after
Secure Mode has been enabled, System Administration Privileges. (see
page 161) are required.
Adding User Accounts Individually
1. From the Security tab in the System Administration Tools window, select
User Accounts...
2. At the bottom on the window, select Add....
3. From the Add-User Account dialog, type in the user's Login Name.
4. Type in the user's Password (see page 162), and then the user's Password
Again.
5. Optional – Type in the user's Encrypted Password.
6. Optional - Type in a Password Age (see page 162).
7. Type in the User Identity and Group Identity.
8. Type in the user's Real Name.
9. Select the File Permissions (see page 174) field, and select the desired
system default read/write permissions.
10. Optional – Check Has Admin Privileges if you want to give the new user
System Administrator privileges.
11. Select Add. Repeat the above from step 3 for the next user account, or,
select Cancel to exit the dialog.
12. Toggle the Secure Mode field to Enabled. Enabling this field will activate
the use of user accounts and set the system to a secured team use
environment.