Installation guide

Contents
9
8 Trigger the Oscilloscope with the Timing Analyzer
Trigger the Oscilloscope with the Timing Analyzer 98
Load the RESET Configuration File 100
Connect the Oscilloscope Probe and Turn the Glitch On 102
Get the Analog Waveform on the Display 103
Set Up the Timing Analyzer 104
Set Up the Timing Analyzer to Trigger on the Glitch 106
Tell the Oscilloscope When to Trigger 108
Set Up the Analyzer to Arm the Oscilloscope 109
Run the Timing Analyzer and Oscilloscope 112
Add the Analog Waveform to the Timing Waveform 114
Turn the Glitch Off 115
Save Your Work 115
Lesson Summary 116
9 Using the Pattern Generator
Using the Pattern Generator 118
Load the RESET Configuration File 120
Connect the Pattern Generator 121
Set Up the Timing Analyzer 122
Set Up the Bus Labels 123
Define the Trigger Conditions: Trigger on a 1 124
Set Up the Pattern Generator 125
Program the Pattern Generator Output 127
Start the Pattern Generator and View the Walking Ones Pattern 130
Stop the Pattern Generator 132
Save Your Work 133
Lesson Summary 134
10 Setting the Jumpers
Setting the Jumpers 138