Installation guide
Table Of Contents
- A Quick Tour
- Before You Begin
- Introduction to Timing Analysis: Trigger on an Edge
- Verify Pulse Widths
- Introduction to State Analysis: Trigger on an Event
- Trigger on a Sequence of Events
- Trigger on a 4 Bit Serial Pattern
- Trigger the Oscilloscope with the Timing Analyzer
- Load the RESET Configuration File
- Connect the Oscilloscope Probe and Turn the Glitch On
- Get the Analog Waveform on the Display
- Set Up the Timing Analyzer
- Set Up the Timing Analyzer to Trigger on the Glitch
- Tell the Oscilloscope When to Trigger
- Set Up the Analyzer to Arm the Oscilloscope
- Run the Timing Analyzer and Oscilloscope
- Add the Analog Waveform to the Timing Waveform
- Turn the Glitch Off
- Save Your Work
- Lesson Summary
- Using the Pattern Generator
- Load the RESET Configuration File
- Connect the Pattern Generator
- Set Up the Timing Analyzer
- Set Up the Bus Labels
- Define the Trigger Conditions: Trigger on a 1
- Set Up the Pattern Generator
- Program the Pattern Generator Output
- Start the Pattern Generator and View the Walking Ones Pattern
- Stop the Pattern Generator
- Save Your Work
- Lesson Summary
- Setting the Jumpers
- About the Credit Card Board
41
Chapter 3: Introduction to Timing Analysis: Trigger on an Edge
Lesson Summary
Lesson Summary
You have learned about basic timing analysis and how to make a basic
timing measurement.
You did the following:
✓ Set up the timing analyzer.
✓ Set up the analyzer to trigger on an edge.
✓ Ran the analyzer and viewed the waveform.
✓ Used markers to make a timing measurement.
✓ Saved your work.
What’s Next?
For more practice making basic timing measurements, go to
chapter 4.
To learn about state analysis and how to make a basic state measurement,
go to chapter 5.
To learn how to trigger the oscilloscope with the timing analyzer, go to
chapter 8.
To learn how to use the pattern generator, go to chapter 9.