User`s guide

Agilent 4155C/4156C User’s Guide Vol.2, Edition 6 2-13
Knob Sweep Measurements
Executing Measurements
Example
The following figure shows an example to set both X axis and Y axis display
regions to positive.
To Stop Measurement
To stop the knob sweep measurement, press Stop front-panel key.
This returns the 4155C/4156C operation state to the previous state. For example, if
the knob sweep measurement starts from the idle state, the operation state returns to
the idle state.
Starting knob sweep again
To start the knob sweep measurement again, press the following front-panel key:
Single The knob sweep measurement will start from the point where it
was stopped.
Green, Single The knob sweep measurement will start from 0 V or 0 A.