User`s guide

2-10 Agilent 4155C/4156C User’s Guide Vol.2, Edition 6
Knob Sweep Measurements
Executing Measurements
Executing Measurements
You can easily execute the knob sweep measurements, as shown below:
1. Defines measurement units on the CHANNELS: CHANNEL DEFINITION
screen.
2. Presses the green key, and then Single key.
NOTE In the knob sweep mode, user functions and user variables are not available. See “To
Use User Function” on page 2-9.
To use PGU in the pulse output mode (MODE=VPULSE), set up the MEASURE:
PGU SETUP screen as same as the normal sweep mode. For setting up the PGU
SETUP screen, refer to Chapter 1.