User`s guide

Agilent 4155C/4156C User’s Guide Vol.2, Edition 6 1-21
Sweep Measurements
Defining Measurement Conditions
To Set up Constant Output
Constant voltage/current source is the measurement unit defined as CONST in the
CHANNELS: CHANNEL DEFINITION screen. To set up the constant output
source, press
Meas front-panel key. The MEASURE: SWEEP SETUP screen is
displayed.
1. CONSTANT : SOURCE
Enter the desired output value of the constant source.
2. CONSTANT : COMPLIANCE
Only for SMU. Enter the compliance value for the constant source.
You cannot change UNIT, NAME, and MODE in this screen. To change the values,
go to the CHANNELS: CHANNEL DEFINITION screen.