User`s guide

10-2 Agilent 4155C/4156C User’s Guide Vol.2, Edition 6
Connecting Measurement Devices
This section describes how to connect device under test (DUT) to the 16442A/B test
fixture, and how to connect cables to the connector plate.
For connecting the test fixture or the connector plate to the 4155C/4156C, see User's
Guide General Information. If you use a wafer prober, see wafer prober manuals.
Note that you must set the 4155C/4156C to the idle state when connecting or
disconnecting DUTs. If not, the DUTs may be damaged.
To set to idle state, press
Stop key and make sure Standby indicator is off.
This section has the following descriptions:
• “Using Test Fixture”
• “Using Connector Plate”