Specifications

Up to 3 GHz (7 mm) Material

Placing the MUT on the Test Fixture as follows:

Furnished Accessories:

Compensation and Measurement: Short compensation

is required before measurement. Short compensation is

performed by only inserting the MUT holder into the test

fixture. After performing short compensation, the MUT is

inserted into the fixture as shown below.

Description P/N Qty.

Fixture Holder 16454-00601 1

Tweezers 8710-2081 1

Screw, Hex Recess 0515-1050 1

Holder A 16454-25002 1

Holder B 16454-25001 1

Holder C (Without hole) 16454-25004 1

Holder D (With hole) 16454-25003 1

Holder Case 1540-0622 1

Hex Key (for replacing fixtures) 8710-1181 1

Carrying Case 16454-60101 1

Operation and Service Manual 16454-90020 1

Remove the cap of the fixture Place a MUT holder only in the fixture Replace the cap by screwing tightly

Remove the cap of the fixture Place a MUT onto the MUT holder and

insert it into the fixture.

Replace the cap by screwing tightly

Short Compensation

E4991A with 16454A