Specifications

16092A Spring Clip Fixture

Terminal Connector: 7 mm

DUT Connection: 2-Terminal

Electrical Length: 3.4 mm

Dimensions (approx.): 150(W) x 70(H) x 80(D) [mm]

Weight (approx.): 180 g

Additional Error: See figure below

Up to 3 GHz (7 mm) Lead Components

Description: This test fixture is designed for impedance

evaluation of both lead and SMD. It is furnished with two

modules that can be readily screwed onto the plate to

measure either lead or SMD.

Applicable Instrument: 4291B*, 4294A + 42942A, 4395A

with Opt. 4395A-010 + 43961A, E4991A, (4287A, 4396B

with Opt. 4396B-010 + 43961A)**

When used with 16085B: 4263B, 4268A, 4279A*, 4284A*,

4285A, 4288A, E4980A, E4981A

* denotes the instrument is obsolete.

** applicable in a limited frequency range.

Frequency: DC to 500 MHz

Maximum Voltage: ±40 V peak max (AC+DC)

Operating Temperature: 0°C to 55°C

DUT Size: See figure below

Furnished Accessories:

Compensation and Measurement: Open and short

compensations are recommended in combination with the

electrical length compensation before measurement. The

fixture’s electrical length must be entered into the electri-

cal length compensation function of the measurement

instrument first. When using the SMD module, open com-

pensation is performed by separating the high and the

low electrodes from each other. The separation should be

equivalent in size to the DUT’s width. Short compensation

is performed by contacting the high and low electrodes

together. When using the lead component module, open

compensation is performed by not having the module-elec-

trodes be connected to anything. Short compensation is

performed by using the furnished shorting plate. After

performing open and short compensations in combination

with the electrical length compensation, the DUT is

inserted into the test fixture.

Description P/N Qty.

Shorting Plate 16092-08010 1

Operating Note 16092-90010 1

Inserting the SMD

Inserting the leaded component

DUT Dimensions