Specifications

DUT Size:
Three types of contact boards are available for the 16043-60011/12 and the contact boards are selected
accordingly to the DUT size and electrodes’ separation. The electrode spacings on the contact boards are
shown in the figure above. The 16043-60011’s contact boards are provided with three groups of elec-
trodes (as shown in the figure above) and the sliding mechanism allows the DUT to slide down to the
next group of electrode. In order to lay the DUT at an appropriate position on the contact board, a
device guide fabricated to fit the size of the DUT is required.
Select the contact boards, that accommodates the DUT size best.
The table to the left shows the applicable DUT sizes for each
contact board.
To maintain the measurement precision, it is recommended to clean the contact boards approximately
every 1,000 times. It is recommended to replace the contact boards approximately every 10,000 times.
20
Test fixture overview
The sliding mechanism of the 16043-60011 allows
the measurement of the load capacitors, by sliding
the DUT and the device guide to the next electrode
on the contact board. It is necessary, to raise the
pressure arm before the DUT is moved.
Sliding mechanism for 16043-60011
Up to 110 MHz (4-Terminal Pair) SMD
Contact Board
Applicable
DUT Size
No.1
8.1 mm × 4.5 mm to
3.7 mm × 3.1 mm
No.2
3.7 mm × 3.1 mm to
2.5 mm × 2.0 mm
No.3
2.5 mm × 2.0 mm to
2.0 mm × 1.2 mm
Electrode configuration for 16043-60011/12 contact board