User`s guide

General Information

Introduction

11970 Series Harmonic Mixers

Figure 1-1

Options

Option 009, shown in Figure 1-2 on page 13, is a Mixer Connection Kit. It includes three low-loss SMA

cables (Part Number 5061-5458), one hex-head balldriver (Part Number 8710-1539) for tightening the

waveguide connector screws, and one 5/16-inch open-end wrench (Part Number 8710-0510) for use on

the SMA connectors.

Spectrum Analyzer Retrofit Requirements

• N9030A Signal Analyzer

— A Diplexer is required since the N9030A has a single SMA external mixer port, and the 11970

series mixers have separate LO and IF ports. The recommended diplexer can be purchased from

Agilent as p/n N9029AE13 or from OML Inc. as p/n DPL.313B.

— Requires Option EXM

To retrofit Option EXM:

— Software revision must be A.08.01 or later

— USB storage device (>2GB free memory)

— The N9030A does not support the 11970K (LO range limitation).

N9030A Frequency Option

Serial Number Prefix

MY/US/SG5138

550, 544, or 543 N9030AK-EXM

N9030AK-EXM

503, 508, 513, or 526 N9030AK-HL6