Technical data

Chapter 5 95
Spectrum Analyzer
Making Distortion Measurements
Spectrum Analyzer
Making Distortion Measurements
This section provides information on measuring and identifying signal
distortion.
This section is divided into the following sections:
“Identifying Distortion Products” on page 96
“Third-Order Intermodulation Distortion” on page 99
CAUTION Ensure that the total power of all signals at the analyzer input does not
exceed +33 dBm (2 watts).
Basic Assumption
The material in this section is presented with the assumption that you
understand the front and rear panel layout, and display annotations of
your analyzer. If you do not, refer to the Measurement Guide “Front and
Rear Panel Features”.