Technical data

162 Chapter 10
Basic System Operations
Saving, Recalling, and Deleting Instrument States
Basic System Operations
Deleting States
If you have saved a state you will no longer use, you can delete it.
1. Press Recall, Type, State, Device (Internal), Catalog.
2. Select from the file list the state file you want to delete using the
knob or up and down arrow buttons or
All to delete all saved states.
All states, in addition to two supplied in the analyzer (listed below),
are displayed. DO NOT delete either of the following files:
• Powerup - The default power-up state shipped with the analyzer,
or the power-up state last saved with the analyzer.
• Factory Defaults - The default power-up state shipped with the
analyzer. You can always revert to it by selecting it in this
procedure.
3. Press Select. You will then be asked, “Are you sure you wish to
delete the <filename> state?” Press
Yes.
NOTE Selecting All does not delete the Powerup or Factory Defaults states.