Technical data

14 Chapter 1
Installation and Setup
Safety Information
Installation and Setup
Safety Information
General
This product and related documentation must be reviewed for
familiarization with safety markings and instructions before operation.
This product has been designed and tested in accordance with IEC
Publication 61010-1+A1+A2:1992 Safety Requirements for Electrical
Equipment for Measurement, Control and Laboratory Use and has
been supplied in a safe condition. This instruction documentation
contains information and warnings which must be followed by the user
to ensure safe operation and to maintain the product in a safe condition.
Safety Earth Ground
An uninterruptible safety earth ground must be provided from the main
power source to the product input wiring terminals, power cord, or
supplied power cord set.
Chassis Ground Terminal
To prevent a potential shock hazard, always connect the rear-panel
chassis ground terminal to earth ground when operating this analyzer
from a dc power source.
Safety Information
The following safety conventions are used throughout this manual.
Familiarize yourself with the symbols and their meaning before
operating this instrument.
WARNING A Warning denotes a hazard. It calls attention to a procedure
which, if not correctly performed or adhered to, could result in
injury or loss of life. Do not proceed beyond a warning note
until the indicated conditions are fully understood and met.
CAUTION A Caution denotes a hazard. It calls attention to a procedure that, if not
correctly performed or adhered to, could result in damage to or
destruction of the instrument. Do not proceed beyond a caution sign
until the indicated conditions are fully understood and met.
NOTE A Note calls out special information for the user’s attention. It provides
operational information or additional instructions of which the user
should be aware.