Service manual

11713A Operating and Service Manual 4-3

Verification

Operator’s Check for Local Operation

This check tests initial driver turn-on and local operation.

Check that the following initial conditions are met before you proceed.

❏ Verify that driver power transformer primary is matched to the line

voltage by the Line Voltage Selection Card.

❏ Check the driver power fuse for correct rating. Current fuse ratings

for various line voltages are given on the line power module on rear

panel.

❏ Connect the power cable to the power receptacle.

Procedure

1. Connect the equipment that is to be used in your application as

shown below.

Figure 4-1 Local Operation Test Setup