Service manual

11713A Operating and Service Manual 2-11
Installing the Agilent Technologies 11713A Attenuator/Switch Driver
Connecting to Four-Section
❏ To use one four-section attenuator assembly, connect an attenuator
cable to either the ATTEN X output (A6J1) or ATTEN Y output
(A6J2). Connect both outputs to have more than four attenuator
segments.
Figure 2-6 shows a typical connection for a programmable
four-section attenuator and illustrates the connection/pin number
for each connector: ATTEN X or ATTEN Y Using these same
connections to Agilent 8762 or 8765 series coaxial switches, control
can be extended to four, eight, or ten switches if S0 and S9 outputs
are also used.
Figure 2-6 Typical Connections for Programmable Four-Section
Attenuator