Service manual

1-4 11713A Operating and Service Manual
Agilent Technologies 11713A Attenuator/Switch Driver
Overview
Connecting Accessories
Table 1-3 lists accessories that are available for the 11713A
attenuator/switch driver. Supplied accessories include two dual Viking
connector cables, 12-pin conductor, 60 inches long, and a line power
cable. Refer to "Replaceable Parts".
Table 1-3 Available Accessories
Recommended Test Equipment
Recommended test equipment for verifying performance and for
troubleshooting the 11713A attenuator/switch driver is given in Table
4-1.
Accessories Available But Not Supplied
Interconnect kit (Type-N connectors)
a
Agilent 11716A
Interconnect kit (7-mm connectors)
a
Agilent 11716B
Interconnect kit (SMA connectors)
a
Agilent 11716C
Attenuator/switch driver rear cord wrap kit
b
Agilent 5062-3995
Viking connector to four ribbon cables to connect up to
four switches
Agilent 11761A
Viking connector to 10-pin DIP connector, 60 inches long Agilent 11764B
9-Pin conductor cable, to Viking connector (for five
switches), 60 inches long.
8120-2178
12-Pin conductor cable, bare wire to Viking connector
(for five switches, 60 inches long.
5061-0969
a.Order this kit to connect two programmable step attenuators in series.
b.Order this kit to set the driver on the rear panel for bench operation.