User`s guide

2 Displaying Data
50 Agilent 1000 Series Oscilloscopes User’s Guide
To change the Volts/Div control sensitivity
When you need to adjust the amplitude/div setting in smaller increments,
you can change the sensitivity ofthe vertical scale control.
1 If the channel’s menu is not currently displayed, press the channel key
([1], [2], [3], or [4]).
2 In the Channel menu, press Volts/Div to toggle between:
You can also toggle between coarse and fine settings by pushing the
vertical scale knob (see “To adjust the vertical scale” on page 44).
To invert a waveform
You can invert a waveform with respect to the ground level.
1 If the channel’s menu is not currently displayed, press the channel key
([1], [2], [3], or [4]).
2 In the Channel menu, press Invert to toggle between “ON” and “OFF”.
Figure 21 and Figure 22 show the changes before and after inversion.
Coarse The verical scale knob changes the amplitude/div setting
in a 1- 2- 5 step sequence from 2 mV/div to 10 V/div
(with “1X” probe attenuation).
Fine Also known as vernier, the vertical scale knob changes
the amplitude/div setting in small steps between the
normal (coarse scale) settings.