User`s guide

Oscilloscope Utility Settings 6
Agilent 1000 Series Oscilloscopes User’s Guide 133
To set the mask test output condition
1 In the Mask Test menu ([Utility]>Mask Test), press Output.
2 Continue pressing the Output softkey to select the desired output
condition:
The output condition can be used to stop a running mask test or as a
source for the waveform recording function (see “Recording/Playing- back
Waveforms” on page 78).
To stop a mask test on the output condition
To turn on/off stopping the mask test when the output condition occurs:
1 In the Mask Test menu ([Utility]>Mask Test), press Stop On Output to
toggle between OFF and ON.
To set up masks
You can create masks by adding horizontal and vertical margins to a
signal. You can save and load masks from internal memory or an external
USB drive. And you can export and import masks from an exteral USB
drive.
To access the Mask menu:
1 Press [Utility].
2 In the Utilities menu, press Mask Test.
3 In the Mask Test menu, press MaskSetting.
Fail A mask failure sets the output.
Fail +
A mask failure sets the output and causes a beep.
Pass A passing waveform sets the output.
Pass +
A passing waveform sets the output and causes a beep.