Operation Manual

System Telephone

ST 30

Place of installation

Install ST 30 in an appropriate place. Please pay attention to the following during the installation:

- Not in places,where the phone can be sprayed with water or chemicals.

- Synthetic support at the base of the phone:

Your apparatus was manufactured for normal conditions of use.Chemicals used in the production

or care of furniture can cause changes to the synthetic support of the phone. Such apparatus-

supports changed by extraneous influence can leave behind unpleasant marks. Due to

understandable reasons,liability for such damages can not be taken. Use therefore a non-slippery

base for your phone,especially on new or freshly vanished furniture.

Cleaning

You can easily clean your phone. Pay attention to the following:

- Wipe the phone with slightly moist or antistatic cloth.

- Never use dry cloth (charging could lead to defective electronics).

- Take care by all means that moisture does not ooze into the phone

(switch and contacts could be damaged).

Inserting inscription for the function keys

Use a finger-nail between the upper end of the window and the

phone casing. Pull the window downwards until it buckles.

You can now take it out.

Insert the inscription strips. You can print corresponding lebels on

your PC, using the TK-Set configuration programm.

Re-insert the window at the lower end in the recess for inlay.By

pressing downwards,the window buckles and you can replace it.

Connecting ST 30

- Insert the western plug in an ISDN-slot of the internal ISDN-connection of your AGFEO

telecommunications system until it audibly clicks into place. To release the ISDN-connection

cable,press (with a small screw-driver,if necessary) the notch-hook of the western plug in the

direction of the plug-body and,at the same time, pull out the cable-plug.

Two digital ST 30´s can be connected to each internal ISDN-line of an AGFEO ISDN-

telecommunications system.

During the configuration of the telecommunication system, each ST 30, like any other end

appliance, is assigned a primary internal phone number and possibly a secondary one from the

stock of telephone numbers of the telecommunications system.

Registering ST 30 extension

numbers