Scanner User Manual
Table Of Contents
- Preface
- 1 — Preparing the scanner
- 2 — Installing the scanner for the Macintosh computer
- 3 — Installing the scanner for the PC
- Hardware requirements
- Installation of the hardware
- Electronic registration
- Installing the software
- Placing reflective originals
- A — Using the transparency option
- B — Using the automatic document feeder
- C — Troubleshooting
- D — Technical information on the SnapScan 300
- E — Technical information on the SnapScan 600
- F — SnapScan regulation compliance
Chapter 3 — Installing the scanner for the PC 33
5. Snap the diamond shaped wire clips into the clip brackets to secure the
connection.
In case of problems, refer to Appendix C, “Troubleshooting” .
If your SnapScan will be connected to your computer together with other SCSI
devices:
■ If you install the scanner at the end of your SCSI chain:
1. Remove the terminator from the last device in the SCSI chain.
2. Connect the 50-pin end of the SCSI cable to the connector that has become
available on this device.
3. Put the terminator on the free 50-pin connector of the scanner.
4. Connect the 25-pin end of the SCSI cable to the free connector of the
scanner.
5. Snap the diamond shaped wire clips into the clip brackets to secure the
connection.
In case of problems, refer to Appendix C, “Troubleshooting” .