Service manual

Table of Contents
Table of Contents ix
Bridge Loop Sensor........................................................................................4-3
Upper Bridge Servo Motor............................................................................4-4
The Activator Switch......................................................................................4-6
The Bridge Up Sensor ...................................................................................4-7
Bridge Shuttle Motor......................................................................................4-8
Shuttle Light and Heavy Sensors...................................................................4-10
Appendix A: Spare Parts
Index
SECTION III: BUFFER
Chapter 1: Buffer Installation
Introduction....................................................................................................1-1
Buffer Installation Procedures.......................................................................1-2
Unpacking the Buffer.................................................................................1-2
Unlocking the Buffer..................................................................................1-6
Installing the Buffer to the Imagesetter.....................................................1-10
Aligning the Buffer Carriage......................................................................1-19
Chapter 2: Buffer Component Removal/Replacement
Introduction....................................................................................................2-1
Buffer Home and Buffer Processor Sensors.................................................2-2
Buffer Purchase Sensor..................................................................................2-3
Buffer Carriage Drive Motor..........................................................................2-4
Buffer Roller Driver Motor.............................................................................2-5
Appendix A: Spare Parts
Index
SECTION IV: ON-LINE PROCESSOR
Chapter 1: OLP Installation
Introduction....................................................................................................1-1
OLP Work Space Requirements.....................................................................1-2
Space...........................................................................................................1-2
Floor Load...................................................................................................1-2
Electrical......................................................................................................1-2
Operational.................................................................................................1-3