Service manual

Avantra 36/44 Service Manual
2-14 Removal and Replacement
Figure 2-10 Set screw, cable hole.
➀ –Set screw (1/16 " allen). ➁ –Cable hole. ➂–Cable.
15. Slide the cable out of the drum.
Replace:
1. Take about an inch of new cable and bend it at a 90 degree angle using a
pliars.
2. Insert the bent cable end into the cable hole in the Drum. Figure 1-10.
3. Tighten the set screw. Figure 1-10.
4. Turn the drive coupler counterclockwise while maintaining tension on the
cable. Figure 1-7. Wrap the cable at least one and one half times around
the drum.
5. Re-attach the guiding block. Figure 1-10.
6. Continue to turn the drive coupler until the cable wraps 2-3 times more on
the drum. Keep checking that there is no slack on the cable.
7. Reverse the procedure from Step 11 above.
1
3
2