Service manual

Section V: Crane
Removal and Replacement 2-13
11. Remove the E-clip from the guiding bar and slide the bar out. Figure 1-9.
12. By hand, turn the drive coupler clockwise to unwind the cable. Figure 1-9.
13. Using a 5/32" hex wrench, remove the screw from the cable guiding block.
Figure 1-9.
Figure 2-9 Cable drum with guiding bar and block.
➀ –Cable drum. ➁ –Slack safety switch wires.
➂ –Two phillips screws for safety switch. ➃ –Slack safety switch .
➄ –Guiding bar. ➅ –Guiding block. ➆ –One 5/32 " hex screw.
14. Continue to turn the drive coupler clockwise until the set screw is visible in
the drum. Figure 1-10. Use a 1/16" allen wrench to loosen the set screw.
4
1
6
2
7
3
5