Service manual

Avantra 36/44 Service Manual

2-2 Removal and Replacement

2.2 Crane Removal/Replacement

Procedures

2.2.1 Crane On/Off Switch

Tools Required: phillips head screwdriver

Remove:

1. Power down the OLP and disconnect its power plug.

2. Remove the top covers and, using a phillips head screwdriver, remove the

four (4) screws on the top and three (3) screws on the bottom of the right

side panel. Refer to Figure 2-1 and 2-2. Lift and remove the side panel.

Figure 2-1 OLP cover and panel identiﬁcation and location.

➀

–Forward top cover.

➁

–Middle top cover.

➂

–Rear top cover.

➃

–Top side panel.