Service manual

Section V: Crane

Mounting 1-5

6. Lift the base of the boom into the adapter/mount. Route the power cable

exiting the boom base down through the mount center. Refer to Figure 1-4.

7. Lower the boom into position until the boom ﬁts snugly into the adapter/

mount. Refer to Figure 1-4.

8. With the boom/adapter in place in the mount, connect the boom power

cable to the matching plug at the OLP. Refer to Figure 1-4.

Figure 1-4 Crane power cable connections.

➂

–Mount.

➃

–Mounting bracket.

⑤

–Electrical cable with connector.