Service manual

Avantra 36/44 Service Manual

1-4 Mounting

4. Insert the adapter into the mount and secure with the two (2) set screws

and locking nuts. Refer to Figure 1-3.

Figure 1-3 Inserting the adapter into the mount.

➀

–Boom.

➁

–Adapter (fit into mount).

➂

–Mount.

NOTE:

Later OLP models should not require the following proce-

dure.

5. Replace the top side panel to the OLP and verify that the panel cut-out for

the crane has an acceptable ﬁt. Refer to Figure 1-2 and Figure 1-3.

If the ﬁt is not good, remove the adapter and mounting plate. Re-install the

plate with washers added between the mounting plate and the frame. This

will improve the alignment.

2 1