Service manual

Section IV: On-line Processor

Removal and Replacement 3-25

8. Remove the wires in the terminal block located on the left side of the housing:

a. #1

b. #3

c. #2

d. #4 (green/yellow ground wire)

Refer to Figure 3-20.

CAUTION: Note the numbering of the wires for proper replacement.

Remove the two (2) screws in the terminal block. Refer to Figure 3-20.

9. Remove the two (2) blower mount screws and pull the housing out.

Figure 3-20 Dryer blower assembly.

➀–Blower/dryer assembly. ➁–Terminal block. ➂–Blower mount screws.

1324