Service manual

Avantra 36/44 Service Manual

3-2 Removal and Replacement

3.2 Drive Motor

The following describes how to remove and replace the drive motor.

Tools Required: Phillips screwdriver, 13mm socket and ratchet wrench

Remove:

1. Turn off and unplug the OLP.

2. Remove the side panel at the top left.

3. Using a phillips screwdriver, remove the bracket with the encoder sensor/

sensor connector attached. Refer to Figure 3-1.

Figure 3-1 The drive motor.

➀

– Drive wheel set screw.

➁

–Drive wheel.

➂

–Drive belt.

➃

–Idler.

➄

–Three mounting bolts.

➅

–Encoder disk.

➆

–Encoder sensor/sensor connector.

➇

–Drive motor.

➈

–Drive motor power connectors (M1, M2).