Service manual

Section IV: On-line Processor
Installation 1-23
8. Raise or lower the OLP and/or buffer leveling feet at the bottom until the
platens align. Refer to Figure 1-18.
9. Push the buffer (attached to the imagesetter) flush against the OLP.
10. Lower the feet at the front of the imagesetter to hold the imagesetter/buffer
assembly tightly against the OLP.
Figure 1-18 Adjusting the buffer legs for buffer to OLP alignment.
➀–OLP ➁– Adjustable leg. ➂–Buffer. ➃–Imagesetter
➄–Leg adjustment screw.
3
4
1 2
5