Service manual

Section IV: On-line Processor
Installation 1-13
1.4 Installation Procedures
1.5 Tools and Equipment Required for
Installation
The following tools and equipment are required to perform installation, set-up,
and checkout of the processor.
• Digital Voltmeter (DVM)
• Phillips and slotted-head screwdrivers
• Level
• Darkroom thermometer (long barrel, non-mercury type)
• Adjustable open-end wrench
• 500 ml graduate
1.5.1 Attaching the Legs and Feet
NOTE: Do not remove the engine from the dollies until the legs, lev-
eler feet (two at the top) and stabilizer bar are attached to
the frame.
1. Using a hex driver, attach the two (2) legs to the bottom of the OLP engine
frame. Refer to Figure 1-10 and Figure 1-11.
Attach the lower bolts first, followed by the upper ones. This helps make
bolt alignment easier.
2. Attach the stabilizer bar to the bottom set of legs on the left side. Refer to
Figure 1-10 and Figure 1-11.