Service manual

Section IV: On-line Processor
Installation 1-3
Imagesetter Electrical
Volts: 115/230
Amp: 5 / 2.5
Rec: NEMA 5-20R
Power: 575 Watts
1.2.4 Operational
OLP Water Requirements
Water connection: 3/4" BSP (0.3-10 bar, max. temp. 110˚ /43˚C)
Drain: 5.3 US Gal. (3 x Ø25 mm, 3 x 20 L/min)
Water consumption: 0.5 US Gal. (0-2 L/min)
1.3 OLP Unpacking Procedures
1.3.1 Tools Required for OLP Unpacking
• Crowbar
• Claw hammer
• Strap cutters
1.3.2 OLP Inventory
The Avantra 36/44 OLP arrives in two crates. The top crate contains the OLP
parts including:
1. Receiver basket (1 of 2)
2. Receiver basket (1 of 2)
3. Rear exit panel (bottom)
4. Middle top cover
5. Rear exit panel (top)
6. Rear top side panel
7. Rear top side panel
8. Front top Side panel (control)
9. Evaporation cover
10. Right lower door