Service manual

Avantra 36/44 Service Manual
1-12 Installation
22. Remove the end cap and jack screw from under the unit.
WARNING:
Block the wheels on the left side of the unit to keep the
unit from rolling during the next steps.
23. Open the right side cover on the unit. See Chapter 4, Section 4.2.2, Top,
Middle, and Bottom Panels.
24. Position the jack screw in the access hole between the vacuum pump and
the electrical box. Refer to Figure 1-8.
Figure 1-8 Using the jack screw and plate for raising the imagesetter (right
side).
➀ –Pump. ➁ –Jack screw. ➂ –Electrical box. ➃ –Jack screw (dimpled) plate.
25. Position the jack screw (dimpled) plate below the access hole and turn the
jack screw until the unit begins to lift. Refer to Figure 1-8.
26. Release the unit from the pallet by removing the two (2) outer bolts and
their spring clips. Refer to Figure 1-7.
27. Lower the unit to the ground by turning the jack screw.
28. Remove the two (2) steel channels to the right and left by sliding them
free.
29. After unpacking the imagesetter, inspect tor incorrect, missing, or damaged
items.
1 3
4
2
WARNING: BLOCK LEFT SIDE
WHEELS BEFORE LOWERING