Service manual

Avantra 36/44 Service Manual

2-6 Removal and Replacement

Figure 2-5 Buffer roller drive motor.

➀

–Buffer carriage.

➁

–Buffer roller drive motor.

➂

–Screws securing motor (two each side).

➃

–Three motor mounting screws.

➄

–Drive motor allen screw.

➅

–Drive gear.

4. Pull the encoder plug from the motor.

5. Remove the four (4) 1/4" screws, two (2) on each side, securing the motor.

Refer to Figure 2-5.

6. Cut the tie wrap holding the wires to the motor.

7. Remove the three (3) 3/16" motor mounting screws from the back of the

motor bracket. Refer to Figure 2-5.

8. Remove the set screw from the gear. Refer to Figure 2-5.