Service manual

Avantra 36/44 Service Manual
2-4 Removal and Replacement
2.4 Buffer Carriage Drive Motor
The following describes how to remove and replace the buffer carriage drive
motor.
Tools Required: 1/4" open end wrench
Remove:
1. Remove the top cover from the buffer.
2. Remove the four (4) screws from the brace located in the top center of the
buffer. Refer to Figure 2-3.
Figure 2-3 Carriage drive motor cover.
➀ –Four cover mounting screws. ➁ –Carriage drive motor cover.
➂ –Carriage drive motor. ➃ –Lead screw.
3. Remove the two (2) screws on the motor bracket. Refer to Figure 2-4.
4. Using a flathead screwdriver, disconnect the two (2) P-clips attached to the
bracket. Refer to Figure 2-4.
5. Cut the tie wrap.
6. Remove the lead screw. Refer to Figure 2-4.
1
1 2 43