Service manual

Avantra 36/44 Service Manual
1-6 Installation
9. Each person must grip the unit at the top of the side panel opening. Refer
to Figure 1-4. Lift the unit free of the pallet, and set the unit on the floor.
WARNING:
Do not try to lift the buffer unit from the top, nor should
it be tilted. The top cover on the unit is not attached and will come
off.
10. Replace the side panels at the bottom of the unit frame. Refer to Figure 1-4.
CAUTION:
Do not force the side panels back into place. Doing so
could bend and break the lock pins.
1.2.2 Unlocking the Buffer
The buffer comes with a kit for preparing the unit. Check the kit’s contents against
the hardware shown in Figure 1-5.
Figure 1-5 Hardware for preparing the buffer.
➀ –Two hex bolts (for buffer/imagesetter interface). ➁ –Plastic plugs.
1
2