Service manual

Avantra 36/44 Service Manual

1-4 Installation

5. Using a 7/16¨ hex wrench, remove the two (2) bolts in each of the outrig-

gers at the bottom rear of the unit. Refer to Figure 1-3.

NOTE:

Remove the outriggers at the rear of the unit only.

6. Using a 9/16¨ hex wrench, remove the two (2) bolts from the bottom left

and two (2) bolts from the bottom right of the pallet. Refer to Figure 1-3.

7. Remove the anti-static bag covering the unit.

Figure 1-3 Removing the rear outriggers and pallet bolts.

➀

–Shipping strap.

➁

–Two rear outriggers.

➂

–Two 7/16

hex outrigger bolts.

➃

–Pallet bolts (located under unit)