Service manual

Avantra 36/44 Service Manual

4-10 Removal and Replacement

4.9 Shuttle Light and Heavy Sensors

Tools: Flathead screwdriver

Remove:

1. Using a ﬂathead screwdriver, remove the two (2) mounting screws. Refer

to Figure 4-8.

Figure 4-8 Shuttle light and heavy sensor assembly.

➀–Bridge shuttle motor. ➁–Cover. ➂–Shuttle light and heavy sensor assembly.

➃–Two mounting screws. ➄–Two sensor assembly connectors.

2. Remove the two (2) sensor connectors. Refer to Figure 4-8.

3. Remove the single screw securing the sensors in place.

Replace:

1. Reverse the above procedures.

2. Put the system through a practice run to make certain that the sensors run

properly.