Service manual

Avantra 36/44 Service Manual

4-2 Removal and Replacement

4.2 Removing and Replacing the Bridge

Foot

Tools: None

Remove:

1. Put the bridge in the down position and in heavy mode.

2. Unscrew the two (2) thumb screws, one on each side of the foot. Refer to

Figure 4-1.

Figure 4-1 Bridge foot.

➀–Foot face plate. ➁–Six (three each side) face plate screws.

➂–Two thumb screws. ➃–Media purchase sensor connector.

➄–Loop sensor connector.

3. Lift the bridge and pull the foot out.

Replace:

1. Reverse the procedures above.