Service manual
Avantra 36/44 Service Manual
1-18 Installation
1.5.5 Setting up the DEC to Bridge/Buffer Interface
Tools required: Screwdriver
Steps
1. Using the four standoffs and nylon washers, install the Bridge/buffer inter-
face board on the right wall of the imagesetter. Refer to Figure 1-19.
Figure 1-19 Attaching the bridge/buffer interface board.
➀–Bridge/buffer interface board. ➁–Standoff and nylon washer.
➂–Interface board cover (attach after connectors are in place).
➃–Four hex screws.
The interface board should be positioned so that the cable connector
appears on the lower right. Refer to Figure 1-19.
NOTE: Do not attach the cover until the connector plugs are
attached (see steps below).
1
2
3
4