Service manual

1-1
Chapter 1:
Bridge Installation
1.1 Introduction
This chapter describes the steps necessary for installing the internal bridge and
for insuring that it functions properly.
The following takes you through the necessary procedures:
• Removing the Imagesetter Top Cover
• Attaching the Capture Bar to the Bridge
• Raising and Lowering the Bridge into the Imagesetter
• Attaching the Bridge to the Imagesetter
• Attaching the Bridge Foot
• Attaching the Gas Shocks
• Adjusting the Detent Plate
• Aligning the Solid Stops
• Setting up the DEC to Bridge/Buffer Interface
• Attaching the Ground Wires