Service manual

Section I: Imagesetter
Removal and Replacement 4-63
Figure 4-45 Removing the light shield to access the supply spindle select
motor coupler screws.
–Imagesetter.–Light shield. –SDM board. –Three light shield hex screws.
–Two mounting screws. –Supply spindle select motor.
Figure 4-46 Removing the select motor coupler.
–Coupler housing.–Coupler. –Supply spindle select motor.
–Two coupler allen screws on motor shaft side.
–Motor shaft. –Two housing screws.
1 2
4
5 63
1 2 3
6
54