Service manual

Avantra 36/44 Service Manual

4-48 Removal and Replacement

Figure 4-32 Spin motor module (SMM).

➀

–Spin motor module.

➁

–Mounting bracket.

➂

–Three allen screws

➃

–Spin motor cable.

➄

–Spin motor encoder cable.

4. Cut the tie clamps.

5. Loosen the three (3) allen screws that secure the spin motor mounting

bracket to the carriage casting. Refer to Figure 4-32.

6. Slide the spin motor out of the mounting bracket. Refer to Figure 4-32.

Replace:

1. Orient the alignment key on the spin motor with the slot in the carriage

casting.

2. Slide the spin motor forward through the mounting bracket.

3. Push the spin motor ﬁrmly against the front locating pin and tighten the

spin motor mounting bracket allen screws.