Service manual

Section I: Imagesetter
Removal and Replacement 4-43
Figure 4-29 Carriage assembly.
➀ –Carriage board. ➁ –Spin motor assembly. ➂ –Analog encoder.
➃ –Analog encoder coupler.
8. Push the carriage to the transfer tool carriage stop.
9. Engage the locking pins on the side of the transfer tool. Refer to Figure 4-27.
10. Loosen the two (2) retaining bracket screws that hold the bearing retainer
bracket in the up position on the transfer tool. Refer to Figure 4-27.
The bearing retainer bracket moves down to secure the carriage bearings.
11. Tighten both retainer screws. Refer to Figure 4-27.
12. Loosen the two (2) retainer screws that hold the magnet bracket in the up
position on the transfer tool. Refer to Figure 4-30.
2
3
1
4