Service manual

Avantra 36/44 Service Manual
4-42 Removal and Replacement
4.5.2 Carriage Assembly
Tools Required: Carriage transfer tool
Carriage Removal to Transfer Tool:
1. Refer to the carriage transfer tool installation in Section 4.5.1, Carriage
Transfer Tool Installation.
2. On the right side of the drum, remove the flex cable going to the carriage
board.
3. Move the carriage gently to the left side of the drum.
4. Remove the two (2) power cable connectors going to the brushes on the
inner shrouds.
5. Loosen the four (4) screws securing the left inner shroud to the carriage.
Remove the shroud.
6. Loosen the four (4) screws securing the right inner shroud to the carriage.
Remove the shroud.
7. Gently push the carriage assembly onto the carriage transfer tool. Refer to
Figure 4-29.
Some resistance will be felt when the magnets break free from the carriage
rails.