Service manual

Avantra 36/44 Service Manual

4-40 Removal and Replacement

4.5 Carriage Drive Removal/Replacement

Procedures

The following describes the carriage drive removal/replacement procedures.

4.5.1 Carriage Transfer Tool Installation

Tools Required: phillips screwdriver

NOTE: It is recommended that you remove the left side cover

before you install the carriage transfer tool.

Remove:

1. Open the right and left side covers. See Section 4.2.1, Right/Left Side Cov-

ers.

2. Remove the right and left inner light shields. See Section 4.6.1, Light

Shields (Right and Left).

3. Remove the two (2) screws securing the left end carriage stop to the

engine frame.

4. Assemble the Carriage Transfer Tool. Refer to Figure 4-27.

Both sides are pinned for proper orientation.

Figure 4-27 Carriage transfer tool.

➀

–Alignment pin.

➁

–Screw.

➂

–Handle.

➃

–Carriage stop pin.

➄

–

Retaining bracket screws (2 on each side).

➅

–

Locking pin (2) not shown.

➆

–

Left rail alignment pin .