Service manual

Section I: Imagesetter

Removal and Replacement 4-37

2. Loosen the 1/4" hex screw securing the plate over the power-on switch.

Refer to Figure 4-24.

Figure 4-24 Main power switch and plug locations.

➀–Main power switch and plugs.

3. Slide the plate down and out of the OCP.

4. Remove the brown and blue wires going to the power switch. Refer to

Figure 4-24.

Note the wiring orientation for re-installation.

5. Using your ﬁngers, squeeze both the top and bottom back of the switch

while pushing the switch forward through the control panel bezel.

Replace:

1. Reverse the removal procedure to re-install the main power switch.

2. Turn the power on and check the power light-on switch.