Service manual

Section I: Imagesetter

Removal and Replacement 4-31

Figure 4-21 Operator control panel (OCP).

➀–Power cord clamp. ➁–Removable mounting bracket’s 1/4" hex screw.

➂–1/4" hex screws (2) securing OCP ribbon cable bracket.

➃–Power supply connector. ➄–AC power connector.

➅–OCP ribbon cable. ➆–Removable mounting bracket’s 5/16" hex screw.

4. Remove the hex screw securing the power cord clamp to the electronics

enclosure. Refer to Figure 4-21.

5. Remove the power connector located below the control panel.

6. Remove the power connector going to the power supply. Refer to

Figure 4-21.

7. Loosen the 1/4" hex screw securing the OCP assembly to the removable

mounting bracket. Refer to Figure 4-21.

8. Remove the 5/16" hex screw securing the removable mounting bracket to

the electronics enclosure. Refer to Figure 4-21.