Service manual

Section I: Imagesetter

Removal and Replacement 4-29

5. On the left side of the system, disconnect the spin motor cable, spin motor

encoder cable, carriage motor cable and analog encoder cable from the

CSDM PCB. Refer to Figure 4-20.

Figure 4-20 Carriage sensor driver module PCB (CSDM) (left side).

➀–CSDM PCB. ➁–3/16" hex screws and retaining clip.

➂–Spin motor cable connector. ➃–Spin motor encoder cable connector.

➄–Carriage motor cable connector. ➅–Analog encoder cable connector.

6. Remove the two (2) 3/16" hex screws and retaining clip securing the CSDM

to the carriage assembly. Refer to Figure 4-20.

7. Slide the PCB out of the carriage assembly.

1 3456